Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario descargar pdf (Pagina 49)

Target module »U2-R-CPU«

Target and user modules · 45

Installation

Connecting the target computer

RS232: Use the RS232 cable to connect the computer’s 9-pin serial computer inter-

face to this interface (optional).

Trans.: Use a category 5e (or better) twisted pair cable to connect this interface to the

Dynamic

Port of the USB/RS232 Main Channel that is assigned to the target computer.

USB CPU: Use the USB device cable to connect one of the computer’s USB ports to this

port.

Power In: Insert the connection cable of the power pack to this interface. Now con-

nect the power cable to the power pack and a power outlet.

Status displays

The blinking Transmission LEDs show the following connection statuses:

LED Status Meaning

Yellow Off No connection to network.

On A user module is accessing the target module.

Green On A user module is accessing the target module.

Blinking No communication with matrix switch.

Flashing Connection to matrix switch established successfully.

No user module is accessing.











1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 123 124

Sin comentarios

Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario Pagina 49