Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario descargar pdf (Pagina 122)

Configuration

118 · Target and user modules

Resetting the default settings

This setting resets the default settings of the extender mode. All settings that have

been changed by the user are reset.

How to reset the default settings of the matrix switch:

1. Press the Alt+Num (default) hotkey to open the on-screen display.

2. Select Console utility and press Enter.

3. Select Set system defaults and press Enter.

Showing status information

The OSD shows you information about the user module and the connected target

module.

Several menus provide you with the following information:

How to show status information in the OSD:

1. Press the Alt+Num (default) hotkey to open the on-screen display.

2. Select Information and press Enter.

3. Use the arrow keys to select the desired menu item (see above).

4. Press Enter to show the desired information.

5. Press Esc to leave the menu.

FIRMWARE INFO

This menu shows information about the user module (console) and the target module (target).

ID: Device ID

Version: Installed firmware version

Device: Type name

Firmware: Name of installed firmware

HOTKEY

Local Hotkey (Modifier+Key)

Modifier: Modifier key of key combination

Key: Hotkey of key combination

Local OSD via 2x keypress

Modifier: Configured key to oprn the on-screen display via double keypress

Local selectkeys

Keys: Selected set of select keys:

HARDWARE INFORMATION

Serial number: Serial number of user module

1 2 ... 117 118 119 120 121 122 123 124

Sin comentarios

Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario Pagina 122