Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario descargar pdf (Pagina 13)

Target module »DVI-CPU-UC«

Target and user modules · 9

Power supply

Power In: Plug the power cable of the power pack in this interface. Then connect the

power cable to the power pack and a power outlet.

Status displays

The LED on the back panel of the target module shows the status of the external

power pack:

The blinking Transmission LEDs signal the following operating statuses:

LED Status Meaning

Power on The external power pack is connected and the required voltage (12 Volt)

is available.

off The external power pack is not (properly) connected.

LED Status Meaning

Yellow Off No user module accesses the target module.

On A user module accesses the target module.

Blinking The incoming video signal was not detected.

Flashing No voltage at PS/2 interface or USB bus.

Green Off The target module is turned off.

Blinking The power pack is connected and supplies the required power.

The connection to the matrix switch could not be established.

Flashing The connection to the matrix switch is established.

No user module is accessing or the computer is turned off.

On A user module accesses the target module.

A computer is connected and turned on.

Flickering Keyboard and mouse inputs are transmitted by the accessing user module.

The flickering is defined by the user’s inputs.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 123 124

Sin comentarios

Guntermann-drunck DVICenter DP16 Target Modules and User Modules - S Manual de usuario Pagina 13